Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

1. Raise and suitable support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
3. Remove the outer tie rod to steering knuckle retaining nut.



4. Disconnect the outer tie rod from the steering knuckle using the J 24319-B .



5. Loosen the jam nut (2) and remove the outer tie rod (1) from the inner tie rod (3).
6. Inspect the shaft for bent or damaged threads.
7. Clean the tapered surface of the steering knuckle.

1. Lubricate the inner tie rod (3) threads with a suitable chassis lubricant before installing the outer tie rod (1).
2. Install the outer tie rod (1) to the inner tie rod (3). Do not tighten jam nut at this time.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the outer tie rod to steering knuckle retaining nut .

Tighten
Tighten the nut to 63 N·m (47 lb ft).

4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
5. Lower the vehicle.
6. Adjust the front toe. Refer to Wheel Alignment Measurement .