GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 43631 Ball Joint Remover

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rotor. Refer to Rear Brake Rotor Replacement .

  4. Object Number: 649304  Size: SH
  5. Remove the wheel stud from the axle flange using the J 43631 for the 15 series.
  6. Remove the axle shaft for vehicles with 9.5 inch ring gear. Refer to Rear Axle Shaft Replacement .
  7. Remove the rear hub assembly for vehicles with 10.5 inch ring gear. Refer to Rear Axle Shaft Replacement .
  8. Remove the wheel stud from the axle flange using the J 43631 .
  9. Remove the wheel stud from the hub flange using the J 43631 .

Installation Procedure


    Object Number: 360809  Size: SH
  1. Install the stud into the axle flange for the 15 series.
  2. Install the 4 washers and the lug nut to the stud.
  3. Tighten the lug nut in order to draw the stud into the flange until the stud fully seats.
  4. Remove the lug nut and the washers.
  5. Install the axle shaft for the vehicles with 9.5 inch ring gear. Refer to Rear Axle Shaft Replacement .
  6. Install the rear hub assembly for the vehicles with 10.5 inch ring gear. Refer to Rear Axle Shaft Replacement .
  7. Install the rotor. Refer to Rear Brake Rotor Replacement .
  8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.