GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2007 🢒 Savana - AWD 🢒 Diagnostic Navigation 🢒 Programming and Setup 🢒 Windshield Washer Solvent Container Replacement

Removal Procedure

    Object Number: 497983 Size: SH
  1. Open and support the hood.
  2. Remove the upper fender support bar.
  3. Remove the bolt from the washer solvent container.

    4. Object Number: 497985 Size: SH
  4. Lift the washer solvent container up enough pass the horns in order to access the washer hose and the electrical connector.
  5. Disconnect the electrical connector from the washer pump.
  6. Disconnect the washer hose from the washer pump.
  7. Remove the washer solvent container from the vehicle.
  8. Drain the washer solvent reservoir into a suitable container.

    9. Object Number: 497987 Size: SH
  9. Remove the washer pump from the washer solvent container.
  10. Remove the washer solvent container cap.

Installation Procedure

    Object Number: 497987 Size: SH
  1. Install the washer pump to the new washer solvent container.
  2. Install the washer solvent container cap.

    3. Object Number: 497985 Size: SH
  3. Connect the electrical connector to the washer pump.
  4. Remove the cap on the washer pump and connect the washer hose to the washer pump.
  5. Position the washer solvent container into the locating holes in the chassis.

    6. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 497983 Size: SH
  6. Install the washer solvent container with the bolt.

    7. Tighten
    Tighten the bolt to 10 N·m (89 lb in).

  7. Install the upper fender support bar.
  8. Fill the washer solvent container.
  9. Close the hood.