Step | Action | Yes | No | ||||||
---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Fog Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Data Communication Connector End Views | |||||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |||||||
2 | Verify that the rear fog lamps are inoperative. Does the rear fog lamp operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 | ||||||
3 | With the engine OFF, turn the key to RUN and the headlamp switch to PARK. Do the park lamps illuminate? | Go to Step 4 | |||||||
4 | Inspect the SEO 1 fuse. Is the fuse open? | Go to Step 10 | Go to Step 5 | ||||||
5 |
Was a ground signal present? | Go to Step 8 | Go to Step 6 | ||||||
6 | Test for an open, high resistance, or short to voltage in the following circuits:
Refer to Circuit Testing and Wiring Repairs. Did you find and correct a condition? | Go to Step 14 | Go to Step 7 | ||||||
7 |
Was a ground signal present? | Go to Step 13 | Go to Step 9 | ||||||
8 | Test for an open or high resistance in the rear fog lamp supply voltage circuit. Refer to Circuit Testing and Wiring Repairs. Did you find and correct a condition? | Go to Step 14 | Go to Step 12 | ||||||
9 | Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Circuit Testing and Wiring Repairs. Did you find and correct the condition? | Go to Step 14 | Go to Step 11 | ||||||
10 | Repair the fog lamp supply circuit of the inoperative lamp for a short to ground. Refer to Wiring Repairs. Did you complete the repair? | Go to Step 14 | -- | ||||||
11 | Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 14 | -- | ||||||
12 | Replace the rear fog lamp relay. Refer to Relay Replacement. Did you complete the replacement? | Go to Step 14 | -- | ||||||
13 | Replace the rear fog lamp switch. Refer to Rear Fog Lamp Switch Replacement . Did you complete the repair? | Go to Step 14 | -- | ||||||
14 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |