GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2008 🢒 Savana - AWD 🢒 Transmission/Transaxle 🢒 Automatic Transmission - 4L60-E/4L65-E/4L70-E 🢒 Vehicle Speed Sensor Replacement

Removal Procedure
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the electrical connector from the speed sensor.

    3. Object Number: 97102 Size: SH
  3. Remove the bolt.
  4. Remove the speed sensor and the O-ring seal.
  5. Inspect the seal and the transmission case. Replace the seal, if necessary.

Installation Procedure

    Object Number: 97102 Size: SH
  1. Install the speed sensor and the O-ring seal into the transmission.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolt.

    3. Tighten
    Tighten the bolt to 11 N·m (97 lb in).

  3. Install the electrical connector to the speed sensor.
  4. Lower the vehicle.