Tools Required

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement.
3. Remove the 4 bolts and the reinforcement panel.



4. Disconnect the electrical connector from the wiper motor.



5. Remove the 2 bolts from the wiper transmission assembly.
6. Remove the wiper transmission assembly from the vehicle.



7. Remove the drive link from the wiper motor crank arm with the J 39232 .



8. Remove the 2 bolts retaining the wiper motor.
9. Remove the wiper motor from the wiper transmission assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the wiper motor onto the wiper transmission assembly with the 2 bolts.

Tighten
Tighten the 2 bolts to 8 N·m (71 lb in).




2. Install the drive link onto the wiper motor crank arm with the J 39529 .



3. Install the wiper transmission assembly on the vehicle with the 2 bolts.

Tighten
Tighten the 2 bolts to 9 N·m (80 lb in).




4. Connect the electrical connector to the wiper motor .



5. Install the reinforcement panel with the 4 bolts.

Tighten
Tighten the 4 bolts to 9 N·m (80 lb in).

6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement.
7. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
8. Operate the wipers and check for proper operation.