Removal Procedure
- Remove the door handle bezel. Refer to
Door Inside Handle Bezel Replacement
.
- Remove the door trim panel upper extension. Refer to
Upper Extension Trim Panel Replacement
.
- Using a suitable flat-bladed tool, gently pry the manual lock lever from the door trim panel.
- Remove the push in fastener (3) at the front edge of the door trim.
- Remove the cap (5) covering the screw on the rear edge of the trim panel.
- Remove the trim panel screws.
• | Remove the screw (2) from within the opening where the manual door lock lever resides. |
• | Remove the screw (4) from the opening in front of the armrest. |
• | Remove the screw (6) from the rear edge of the trim panel. |
- Carefully slide the trim panel (1) up in order to release the retainers from the door.
- Disconnect the electrical connectors.
Installation Procedure
- Connect the electrical connectors.
- Carefully align the trim panel (1), to the door and slide the panel into the retainer slots in order to install the trim panel to the door.
Notice: Refer to Fastener Notice in the Preface section.
- Install the trim panel screws (2,4,6).
Tighten
Tighten the trim panel screws (2,4,6) to 2 N·m (18 lb in).
- Install the screw cover (5).
- Install the push in fastener (3).
- Install the manual lock lever to the trim panel.
6.1. | Align the manual lock lever to the opening in the door trim panel. |
6.2. | Push inward until the manual lock lever is fully seated into the trim panel. |
- Install the door trim panel upper extension. Refer to
Upper Extension Trim Panel Replacement
.
- Install the door handle bezel. Refer to
Door Inside Handle Bezel Replacement
.