GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The body control module (BCM) supplies battery positive voltage to the individually controlled lamps. In the event that any of these lamps were to remain illuminated for more than 20 minutes with the ignition switch in the OFF position, the BCM will deactivate the inadvertent power supply voltage circuit to prevent a total battery discharge condition.

Voltage for the inadvertent power supply voltage circuit is from the TBC 2C fuse in the instrument panel (I/P) fuse block directly through the BCM to this circuit.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC B1480 Battery Rundown Protection Circuit

Conditions for Running the DTC

The battery voltage must be between 9-16 volts.

Conditions for Setting the DTC

    • The inadvertent power supply voltage circuit is shorted to ground for more than 1 second.
    • There is a loss of the instrument panel fuse block TBC 2C battery supply voltage to the BCM for 1 second while one or more of the lamps in the inadvertent power circuit has been activated.

Action Taken When the DTC Sets

The lamps on the inadvertent power supply voltage circuit will not operate.

Conditions for Clearing the MIL/DTC

    • This DTC will clear on current status after the condition for setting the fault is corrected.
    • A history DTC will clear after 100 consecutive ignition cycles without a fault present.
    • History and current DTCs can be cleared using a scan tool.

Diagnostic Aids

    • Perform a visual inspection for loose or poor connections at all related components. Refer to Testing for Intermittent Conditions and Poor Connections .
    • A short to ground in the inadvertent power supply voltage circuit or the battery positive voltage circuit will cause the TBC 2C fuse to open.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. This step determines if the problem exists in the wiring or the BCM.

  2. After replacement of the BCM you must calibrate the new module for proper operation.

Step

Action

Yes

No

Schematic Reference: Interior Lights Schematics

Connector End View Reference: Lighting Systems Connector End Views or Data Communication Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

Inspect the TBC 2C fuse in the instrument panel (I/P) fuse block.

Is the fuse open?

Go to Step 3

Go to Step 4

3

Test the inadvertent power supply voltage circuit, and the TBC 2C battery supply voltage to the body control module (BCM) for a short to ground. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 6

Go to Step 4

4

Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 6

Go to Step 5

5

Replace the BCM. Refer to Control Module References .

Did you complete the replacement?

Go to Step 6

--

6

  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

Go to Step 2

System OK