Removal Procedure
- Remove the upper intake manifold. Refer to
Upper Intake Manifold Replacement
.
- Remove the fuel pressure dampener retaining clip (7).
- Twist and pull the fuel pressure dampener (6) in order to remove the regulator from the housing using a shop towel to catch any spilled fuel.
- Remove and discard the dampener O-ring seal (5).
- Cover the fuel pressure dampener housing to prevent contamination from entering the fuel system.
Installation Procedure
- Lubricate the NEW O-ring with clean engine oil.
- Install the fuel pressure dampener O-ring seal (5).
- Install the fuel pressure dampener (6).
- Install the fuel pressure dampener retaining clip (7).
- Install the upper intake manifold. Refer to
Upper Intake Manifold Replacement
.
- Tighten the fuel fill cap.
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.
- Inspect for leaks.
8.1. | Turn the ignition ON, for 2 seconds. |
8.2. | Turn the ignition OFF, for 10 seconds. |
8.3. | Turn the ignition ON. |
8.4. | Inspect for fuel leaks. |