Removal Procedure
- Disconnect the engine wiring harness electrical connector (7) from the camshaft position (CMP) sensor wiring
harness jumper.
- Remove the water pump. Refer to
Water Pump Replacement
.
- Remove the CMP sensor bolt.
- Remove the CMP sensor and wiring harness jumper from the engine front cover.
- Disconnect the CMP sensor wiring harness jumper from the CMP sensor.
- Remove the CMP sensor from the wiring harness jumper.
Installation Procedure
Important: Do not reuse the original O-ring seal.
- If reinstalling the old CMP sensor, install a NEW O-ring seal onto the sensor.
- Install the CMP sensor to the wiring harness jumper.
- Connect the CMP sensor wiring harness jumper to the CMP sensor.
- Lubricate the O-ring seal with clean engine oil.
- Install the CMP sensor and wiring harness jumper to the engine front cover.
Notice: Refer to Fastener Notice in the Preface section.
- Install the CMP sensor bolt.
Tighten
Tighten the bolt to 10 N·m (89 lb in).
- Install the water pump. Refer to
Water Pump Replacement
.
- Connect the engine wiring harness electrical connector (7) to the CMP sensor wiring harness jumper.