• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
5-Volt Reference | B1580, B1590 | B1580, B1590 | B1580, B1590 | -- |
Driver/Passenger Mirror Horizontal Position Sensor Signal | B1580 | B1580 | B1580 | -- |
Driver/Passenger Mirror Vertical Position Sensor Signal | B1590 | B1590 | B1590 | -- |
Low Reference | B1580, B1590 | B1580, B1590 | B1580, B1590 | -- |
The Driver Door Switch (DDS) and Passenger Door Switch (PDS) determine the position of the outside rearview mirrors based on inputs from two mirror position sensors, one for vertical position, the other for horizontal position. Five volts is applied to each sensor through a shared 5-volt reference circuit and a shared low reference circuit supplies ground. Each sensor has an individual signal circuit which provides position voltage to the DDS/PDS.
The ignition is ON.
An improper voltage level is seen on the Driver/Passenger Mirror Horizontal Position Sensor Signal circuit.
An improper voltage level is seen the Driver/Passenger Mirror Vertical Position Sensor Signal circuit.
Mirror movement is suspended so long as the fault is present.
• | A current DTC will clear when the fault is no longer present. |
• | A history DTC will clear after 40 malfunction-free ignition cycles. |
Outside Rearview Mirror Schematics
Outside Mirror Description and Operation
Ignition ON, observe the scan tool Mirror Horizontal Position and Mirror Vertical Position parameters. The reading should be between 0.2-4.8 volts and change as the mirror is moved, left, right, up, and down.
• | 5-volt reference circuit terminal 7 |
• | Signal circuit terminal 4 |
• | Signal circuit terminal 5 |
• | Low reference circuit terminal 10 |
⇒ | If the test lamp illuminates, test the appropriate circuit for a short to voltage. |
• | 5-volt reference circuit terminal 7 |
• | Signal circuit terminal 4 |
• | Signal circuit terminal 5 |
• | Low reference circuit terminal 10 |
⇒ | If less than the specified value, test the appropriate circuit for a short to ground. |
⇒ | If not within the specified range, test the 5-volt reference circuit and the low reference circuit for an open/high resistance. If the circuits test normal, test or replace the rearview mirror motor. |
⇒ | If not within the specified range, test the signal circuit for an open/high resistance. If the circuits test normal, test or replace the rearview mirror motor. |
⇒ | If not within the specified range, test the signal circuit for an open/high resistance. If the circuits test normal, test or replace the rearview mirror motor. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• | Control Module References for DDS or PDS replacement, setup, and programming |