GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC B1722 01: Mirror Power Fold Circuit Short to Battery

DTC B1722 02: Mirror Power Fold Circuit Short to Ground

DTC B1722 04: Mirror Power Fold Circuit Open

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Folding Mirror Motor Retract Control

B1722 02

B1722 04

B1722 01

--

Folding Mirror Motor Extend Control

B1722 02

B1722 04

B1722 01

--

Circuit/System Description

The Driver Door Switch (DDS) and Passenger Door Switch (PDS) control the power folding or power extending functions of the outside rearview mirrors. The folding mirror motors are controlled by using bi-directional motor controls through the folding mirror motor retract control circuit and the folding mirror motor extend control circuit.

Conditions for Running the DTC

Mirror folding is requested.

Conditions for Setting the DTC

An improper voltage level is seen on either the folding mirror motor retract control circuit or the folding mirror motor extend control circuit.

Action Taken When the DTC Sets

Power folding mirror operations are suspended so long as the fault is present.

Conditions for Clearing the DTC

    • A current DTC will clear when the fault is no longer present.
    • A history DTC will clear after 40 malfunction-free ignition cycles.

Reference Information

Schematic Reference

Outside Rearview Mirror Schematics

Connector End View Reference

Mirror Connector End Views

Description and Operation

Outside Mirror Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Circuit/System Verification

Ignition ON, using the folding mirror switch, the left and right rearview mirrors should extend and retract as commanded.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector X7 at the appropriate door switch.
  2. Ignition ON, verify a test lamp does not illuminate between the following circuit terminals and ground:
  3. • Control circuit terminal 1
    • Control circuit terminal 2
    If the test lamp illuminates, test the appropriate circuit for a short to voltage.
  4. Ignition OFF, test for infinite resistance between the following circuits and ground:
  5. • Control circuit terminal 1
    • Control circuit terminal 2
    If less than the specified value, test the appropriate circuit for a short to ground. If the circuits test normal, test or replace the rearview mirror motor.
  6. Test for 5-15 ohms of resistance between the control circuit terminal 1 and the control circuit terminal 2.
  7. If not within the specified range, test both control circuits for an open/high resistance. If the circuits test normal, test or replace the rearview mirror motor.
  8. If all circuits test normal, replace the appropriate door switch.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Outside Rearview Mirror Motor Replacement
    •  Control Module References for DDS or PDS replacement, setup, and programming