The transmission control module (TCM) continuously monitors the Alive Rolling Count generated in the body control module (BCM). If the TCM detects errors in the Alive Rolling Count, monitored through the serial data bus, DTC P1762 sets.
DTC P1762 is a type C DTC
This diagnostic procedure supports the following DTC:
DTC P1762 Transmission Mode Switch Signal Circuit
• | Engine speed is 500-6500 RPM for 5 seconds. |
• | Ignition voltage is 8-18 volts. |
The TCM detects 3 error counts out of 10 samples within 10 seconds.
• | The TCM does not request the engine control module (ECM) to illuminate the malfunction indicator lamp (MIL). |
• | The TCM records the operating conditions when the Conditions for Setting the DTC are met. The TCM records this information as a Failure Record. |
• | The TCM stores DTC P1762 in TCM history. |
• | The TCM clears the DTC from TCM history if the vehicle completes 40 warm-up cycles without a non-emission related diagnostic fault occurring. |
• | A scan tool can clear the DTC. |
Step | Action | Values | Yes | No | ||||
---|---|---|---|---|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |||||
2 |
Important:
Does DTC P1762 fail this ignition? | -- | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections | ||||
3 | Replace the BCM. Refer to Control Module References for replacement, setup, and programming. Is the action complete? | -- | Go to Step 4 | -- | ||||
4 | Perform the following procedure in order to verify the repair:
Has the test run and passed? | -- | Go to Step 5 | Go to Step 2 | ||||
5 | With the scan tool, observe the stored information, capture info and DTC info. Does the scan tool display any DTCs that you have not diagnosed? | -- | System OK |