Tools Required
J 44587
Main Shaft Holder
Notice: Do not rotate the transmission
from the nose-up position without installing J 44587. Failure to install J 44587
and rotating the transmission will cause clearance issues during assembly
and possible damage to the transmission.
- Align
J 44587
with the power take-off (PTO) access as follows:
• | The tongue of
J 44587
is facing toward the PTO access. |
• | The bolts holes of
J 44587
are aligned with the 2 front bolt holes of the PTO access. |
- Install
J 44587
into the PTO access.
- Install 2 bolts into
J 44587
and tighten the bolts snugly.
- Position the main housing so that the oil pan is facing up.
- Remove the drain plug (1).
- Remove the drain plug seal (2) from the drain plug (1).
- Remove 12 oil pan bolts (7). Remove the oil pan (3).
- Remove the oil pan gasket (4).
- Remove the transmission internal oil filter (5).
- Remove the transmission internal oil filter seal (6).
Important: The magnet cannot be removed from the oil pan.
- Inspect and clean the transmission oil pan magnet (1) in the oil pan (2).