Tools Required
• | J 43791
Output/Turbine Shaft Bushing Installer |
• | J 44526
Output/Turbine Shaft Bushing Remover |
Removal Procedure
- Install J 44526-2 bolt (8) and J 44526-1 extractor (7) into the bushing (9) .
- Install J 44526-2 bolt (8) into J 44526-1 extractor (7) .
- Install the washer (6) and nut (5) onto J 44526-2 bolt (8).
- Hold the top of J 44526-2 bolt (8) with a wrench and tighten the nut (5) until J 44526-1 extractor (7) engages the bushing (9) .
- Install the bearing (3), washer (2), and nut (1) onto J 44526-2 bolt (8) .
- Install J 44526-3 protector (4) onto J 44526-2 bolt (8) .
- Hold the top of J 44526-2 bolt (8) with a wrench and tighten the nut (1) until the bushing is dislodged .
- Remove the J tools.
- Remove the bushing from
J 44526
.
Installation Procedure
- Install a new output shaft bushing (2) onto
J 43791
(1).
- Using
J 43791
, drive the bushing into the output shaft (3) until
J 43791
(1) is seated to specification.
Specification
Make sure the bushing is pressed flush to 0.25 mm (0.01 in) below the output shaft surface.