1
| Transfer Case Rear Output Shaft Bushing
Procedure
- Install the finger section of the
DT-48734
in front of the bushing.
- Install the forcing tube assembly into the finger section. Ensure the forcing screw is backed out.
- Using a wrench on the forcing screw, remove the bushing.
- Remove the old bushing from the
DT-48734
.
- Install the NEW bushing on the finger section of the
DT-48734
.
- Install the finger section to the forcing tube assembly of the
DT-48734
.
- Position the bushing and tool to the rear case half.
- Install the bushing until the tool bottoms on the rear case half.
Tip
• | Only remove the bushing if faulty. |
• | If the bushing was removed, a new bushing must be installed. |
• | Ensure the bushing is installed squarely into the bushing bore. |
Special ToolsDT-48734
Transfer Case Rear Bushing Remover and Installer
|