• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
The object alarm detection system senses how close the vehicle is to an object. The distance is determined by the 4 ultrasonic sensors located in the rear bumper. The object detection system will notify the driver when backing up at speeds less than 8 km/h (5 mph), which make parking easier and helps you avoid colliding with objects such as parked vehicles. The object detection system will use the rear display indicators and the radio speakers for notification.
Object Detection Connector End Views
Object Detection Description and Operation
⇒ | If one or two indicators of the telltale assembly does not illuminate, test the control circuit(s) for a short to ground or an open/high resistance. If the circuit(s) test normal, replace the telltale assembly information center. |
⇒ | If all the indicators of the telltale assembly does not illuminate, test the supply voltage circuit for a short to ground or an open/high resistance. If the circuit(s) test normal, replace the telltale assembly information center. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for object alarm module replacement, setup, and programming