The active transfer case mode switch circuit consists of 5 modes. The transfer case shift control module supplies 5 volts to the switch through the 5-volt reference circuit. The current travel through the resistor of the currently active mode. The current is then returned to the transfer case shift control module through the switch signal circuit.

The transfer case shift control module constantly monitors this signal voltage to determine the condition of the mode switch circuit.

When each of the modes are selected they complete a circuit through their own specific resistor. The transfer case shift control module continuously monitors the switch input to determine whether the Neutral, 2HI, 4HI, or 4LO mode was selected by the driver.

Schematic Reference

Transfer Case Control Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information.

If the 5-volt reference or the switch signal wire are shorted to ground the scan tool can show up to 7.5 volts.

1. Review the scan tool data list mode switch selected and select difference mode with the transfer case shift control switch. Does the mode switch selected parameter on the scan tool change as you change modes on the switch?
2. If the modes change according to the scan tool replace the transfer case control module, reprogram, complete the motor learn procedure. If the modes on the scan tool do not change replace the switch.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.