The indicator circuits consists of an interior lights dimming circuit and an indicator control circuit. When a mode has been selected, current is supplied to the indicator by the interior lights dimming circuit, traveling through the indicator LED, at which time the transfer case shift control module supplies the ground through the indicator lamp control circuit.

Schematic Reference

Transfer Case Control Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information.

A short to ground on the indicator control circuit will cause the indicator to remain on at all times.

1. With the ignition off disconnect connector X1 at the transfer case control module and turn the ignition on. If the affected indicator goes out replace the transfer case control module, program, and perform the motor learn procedure.
2. If the affected indicator did not go out check for a short to ground on the affected indicator control circuit. If this checks as good then replace the transfer case shift control switch.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.