For 1990-2009 cars only
- Install a new gasket (2) onto the transmission case (3).
- For a 2WD transmission, make sure the output shaft turns with the output speed sensor (OSS) reluctor wheel. For a 4WD transmission, install the output shaft bearing spacer.
- Align the low and reverse clutch housing with the transmission case locating pin (4) and park pawl pin (5).
- Install the low and reverse clutch housing.
- For a 2WD transmission, turn the OSS reluctor wheel through the OSS hole to make sure the output shaft turns with the reluctor wheel.
- Hand install 4 bolts (1).
- Evenly draw down bolts (1) until the low and reverse clutch housing seats on the transmission case.
- Hand install 12 bolts (2).
- Tighten the bolts (1) and bolts (2) to 56 N·m (42 lb ft).
Note: Except as noted, a low and reverse clutch housing, 4WD is installed using the same procedures as used when installing a low and reverse clutch housing, 2WD.
Caution: Refer to Fastener Caution in the Preface section.
