Air Conditioning Cycling Switch Replacement Non-HP2

1. Disconnect the electrical connector from the A/C low pressure switch.



2. Remove the A/C low pressure switch from the accumulator.
3. Remove the O-ring and discard.

1. Install the new O-ring seal to the switch. Refer to O-Ring Replacement.

Caution: Refer to Fastener Caution in the Preface section.




2. Install the A/C low pressure switch to the accumulator and tighten to 6 N·m (53 lb in).
3. Connect the electrical connector to the A/C low pressure switch.
4. Leak test the fittings of the components using the J 39400-A .