Removal Procedure
- Remove the air intake pipe. Refer to
Air Intake Pipe Replacement
.
- Disconnect the engine wiring harness electrical connector (1) from the intake air temperature (IAT) sensor pigtail.
- Remove the IAT sensor (2) from the center intake manifold.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the IAT sensor (2) to the center intake manifold.
Tighten
Tighten the sensor to 25 N·m (18 lb ft).
- Connect the engine wiring harness electrical connector (1) to the IAT sensor pigtail.
- Install the air intake pipe. Refer to
Air Intake Pipe Replacement
.