GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2007 🢒 Sierra - 2WD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Trailer Brake Control Relay Replacement

Trailer Brake Control Relay Replacement 2500, 3500


Object Number: 1862976 Size: MF

Callout

Component Name

Preliminary Procedures

  1. Turn the ignition switch to the OFF position.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

1

Trailer Brake Control Relay Electrical Connector

Procedure

Disconnect the electrical connector.

2

Trailer Brake Control Relay Bolt (Qty: 2)

Notice: Refer to Fastener Notice in the Preface section.

Procedure

Loosen, but do not remove the bolts. It is not necessary to completely remove the bolts.

Tighten
6 N·m (53 lb in)

3

Trailer Brake Control Relay

Procedure

Slide the relay upward to remove.

Trailer Brake Control Relay Replacement 1500

Removal Procedure
  1. Turn the ignition switch to the OFF position.

    2. Note: Do not remove the spare wheel hoist.

  2. Remove the spare tire and wheel assembly. Refer to Spare Wheel Hoist Replacement.

    3. Object Number: 2127555 Size: SH
  3. Disconnect the trailer brake control relay electrical connector.

    4. Note: It is not necessary to completely remove the bolts.

  4. Loosen, but do not remove, the trailer brake control relay bolts (1).

    5. Object Number: 2127559 Size: SH
  5. Slide the trailer brake control relay (1) toward the center of the vehicle and remove the trailer brake control relay.

Installation Procedure

    Object Number: 2127559 Size: SH
  1. If installing a new trailer brake control relay, hand start the 2 trailer brake control relay bolts.
  2. Position the trailer brake control relay to the frame bracket.
  3. Slide the trailer brake control relay (1) toward the left frame rail.

    4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 2127555 Size: SH
  4. Tighten the trailer brake control relay bolts (1).

    5. Tighten
    Tighten the bolts to 6 N·m (53 lb in).

  5. Connect the trailer brake control relay electrical connector.
  6. Install the spare tire and wheel assembly. Refer to Spare Wheel Hoist Replacement.