• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
System Disabled Information Stored Invalid Serial Data Received | -- | -- | -- | C0569 00 |
The electronic brake control module (EBCM) is the control center for the ABS TCS/ESP. The programming and calibration needed by the EBCM to control the operation of the ABS TCS/ESP are stored in the EBCMs read only memory (ROM). The EBCM constantly performs a self test that detects, and isolates ABS TCS/ESP faults.
The ignition is ON.
The EBCM has not undergone the programming procedure.
The driver information center (DIC) displays the SERVICE Antilock Brake System (ABS) warning message.
A current DTC will clear when the EBCM has undergone the setup procedure.
A newly replaced EBCM will set DTC C0569 on its initial ignition ON cycle.
Antilock Brake System Schematics
Antilock Brake System Connector End Views
Scan Tool Data List for EBCM
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.