Preliminary Procedures

1. Remove the battery. Refer to Battery Replacement .
2. Remove the instrument panel (I/P) upper trim pad. Refer to Instrument Panel Upper Trim Panel with Windshield Defroster Nozzle Grille Replacement .
3. Disconnect the upper intermediate steering shaft. Refer to Upper Intermediate Steering Shaft Replacement .
4. Remove the 4 I/P bolts to body bolts.
5. Disconnect the 5 electrical connections on the passenger side.
6. Pull the passenger side of the I/P back approximately 760 mm (2.5 ft) pivoting on the drivers side . Set on floor or seat.
7. Remove the 2 screws from the HVAC recirculation door and push door towards the center of the vehicle. Refer to Air Inlet Assembly Replacement .
8. Disconnect the coaxial cable at the junction.
9. Insert a shim between the HVAC and side metal approximately 38 mm (1.5 in).
10. Tape pull wire to the coaxial cable.

1

Radio Antenna Mast

Notice: Refer to Fastener Notice in the Preface section.

Tighten
6 N·m (53 lb in)

2

Air Inlet Grille Outer Cover

3

Radio Antenna Assembly Screw (Qty: 3)

Tighten
5 N·m (44 lb in)

4

Radio Antenna Assembly

Tip

1. Remove the cable grommet from the body using the screwdriver from top down.
2. Tie a long wire to the antenna cable to aid in installation of new antenna. Use a screwdriver to guide the cable from the inside.
3. Tape a long pull wire to the antenna cable to aid in installation of the new antenna. Use a screwdriver to guide the wire from the inside.
4. Lubricate the grommet to aid in installation.