Callout
| Component Name
|
Preliminary Procedure
• | Using the
J 35512
and an arbor press, remove the bearing assemblies from the drive sprocket. |
• | Ensure the bearings are installed squarely into the drive sprocket bore. |
• | Install the bearings from the top with the clutch teeth facing down. |
|
1
| Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Front
Tip
• | Install the bearing using the long side of the
DT-48211
. |
• | Ensure the flat edge of the bearing is facing upward. |
• | Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket. |
Special Tools
• | DT-48211
Drive Sprocket Bearing Installer |
• | J 35512
Inner Pinion Bearing Installer |
|
2
| Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Rear
Tip
• | Install the bearing using the short side of the
DT-48211
. |
• | Ensure the flat edge of the bearing is facing upward. |
• | Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket. |
Special Tools
• | DT-48211
Drive Sprocket Bearing Installer |
• | J 35512
Inner Pinion Bearing Installer |
|