Callout
| Component Name
|
Preliminary Procedures
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the transfer case shield, if equipped. Refer to
Transfer Case Shield Replacement
.
- Remove the front propeller shaft. Refer to
Front Propeller Shaft Replacement
.
- Remove the control rod. Refer to
Transfer Case Control Rod Replacement
.
|
1
| Transfer Case Control Lever Knob
Procedure
- Using an adjustable wrench, adjust the wrench to fit the control lever rod just below the knob.
- With the adjustable wrench touching the control lever knob, gently tap on the adjustable wrench in an upward motion until the knob is separated from the control lever rod.
|
2
| Transfer Case Control Lever Bezel Screw (Qty: 3)
Notice: Refer to Fastener Notice in the Preface section.
Tighten 12 N·m (106 lb in) |
3
| Transfer Case Control Lever Bezel
|
4
| Transfer Case Control Lever Bolt (Qty: 4)
Tip Tighten bolts in specified sequence.
Tighten 25 N·m (18 lb ft) |
5
| Transfer Case Control Lever
|