Yazaki Connectors 2-Way
Special Tools
J-38125
Terminal Repair Kit
Terminal Removal Procedure
- Disconnect the connector from the component.
- Insert a small flat-blade tool in the slot below the front loaded terminal position assurance (TPA) and pry up.
- Remove the TPA by pulling it out of the connector.
- Push the wire side of the terminal that is being removed toward the connector and hold it in position.
- Insert the J 38125-553 on a slight upward angle into the cavity below the terminal to be removed. Ensure that the pointed
on the end of the tool is facing the bottom of the terminal and it stays in contact with the terminal until it stops on the plastic terminal retainer. See the release tool cross reference in the Reference Guide of the
J-38125
to ensure that the correct release tool is used.
- Gently pry the plastic terminal retainer down and carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal
out of a connector. If the terminal is difficult to remove, repeat the entire procedure.
Terminal Repair Procedure
Use the appropriate terminal and follow the instructions in the
J-38125
.
Yazaki Connectors 16-Way
Special Tools
J-38125
Terminal Repair Kit
Removal Procedure
- While depressing the lock, pull the two connector halves apart.
Note: The TPA is fragile and may break if not done carefully.
- Use a small flat-blade tool to very carefully push the terminal position assurance (TPA) towards the face of the connector on both sides of the connector.
- View of the male half of the connector with female terminals.
- View of the female half of the connector with male terminals.
- Use the J 38125-215 tool to release the terminals by inserting the tool into the terminal release cavity. See the release tool cross reference in the Reference Guide of the
J-38125
to ensure
that the correct release tool is used.
- View of the female half of the connector with male terminals.
- View of the male half of the connector with female terminals.
- While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
Repair Procedure
Use the appropriate terminal and follow the instructions in the
J-38125
.
Location of the terminal in the repair tray and the proper crimp tool can be found in the appropriate connector end view.