Sunroof Housing Drain Gutter Replacement Extended Cab

Important: Tape off the perimeter of the sunroof window opening before removing the sunroof module to prevent scratching.

1. Remove the air deflector. Refer to Sunroof Air Deflector Replacement.
2. Set the sunroof window to be in the open position of a minimum of 25 mm (1 in).

Important: It is only necessary to lower the headlinder. Only do those steps in headlinder replacement that will lower the headlinder enough to grain access.

3. Remove the sunroof module assembly.



4. Remove the screws (1) from the water gutter (2).



5. Slide the water gutter rearward to release the retaining tabs (1) from the slots (2) in the track.
6. Remove the water gutter (3) from the track.

1. Position the sunroof water gutter to the sunroof window track.
2. Seat the retaining tabs (1) on the water gutter (3) into the slots (2) in the track, and push the water gutter forward until the retaining tabs lock into place.
3. Ensure that all 6 tabs are secured.

Notice: Refer to Fastener Notice in the Preface section.




4. Install the water gutter screws (1).

Tighten
Tighten the screws to 2 N·m (18 lb in).

5. Install the sunroof module.
6. Open the sunroof window to the fully open position.
7. Install the air deflector. Refer to Sunroof Air Deflector Replacement.
8. Remove the tape from around the perimeter of the sunroof window.
9. Verify that the sunroof is operating properly.