A new auxiliary body control module (XBCM) must be programmed with the latest operating software and vehicle calibrations. Ensure that the following conditions exist in order to prepare for BCM programming:
• | The battery is fully charged. |
• | The ignition switch is in the ON position. |
• | The data link connector (DLC) is accessible. |
• | All disconnected modules and devices are connected. |
For some export vehicles the additional procedures below are designed to program the export body control module. Before you start, read these procedures carefully and completely.
Important: The vehicle theft system may not operate properly if a replacement XBCM is not properly programmed.
Program the auxiliary body control module. Refer to Service Programming System (SPS) for more information.
Perform auxiliary BCM special function "Enable inclination sensor".
Important: After programming, perform the following to avoid future misdiagnosis: