Preliminary Procedures

Remove the transmission electrical connector. Refer to Automatic Transmission Electrical Connector Passage Sleeve Replacement .

1

Manual Shaft Detent Bolt

Notice: Refer to Fastener Notice in the Preface section.

Tighten
12 N·m (106 lb in)

2

Manual Shaft Detent Assembly

3

Control Valve Assembly Bolt (Qty: 6)

Procedure

Tighten
8 N·m (71 lb in)

4

Control Valve Assembly

5

Fluid Pump Seal

Procedure

Discard seal and replace with new.

6

Fluid Pump Seal

Procedure

Discard seal and replace with new.

7

Center Support Fluid Passage Seal

Procedure

1. Discard seal and replace with new.
2. It is recommended that transmission adaptive pressure (TAP) information be reset. Transmission performance may be affected as new TAP values are learned. Refer to Service Fast Learn Adapts .
3. If replacing the control valve body assembly, remove the Control Solenoid Valve and Transmission Control Module Assembly Replacement and the Manual Shift Shaft Position Switch Replacement .