For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0550 00: Electronic Control Unit (ECU) PerformanceDTC C0550 01: Electronic Control Unit (ECU) Performance
DTC C0550 02: Electronic Control Unit (ECU) Performance
DTC C0550 03: Electronic Control Unit (ECU) Performance
DTC C0550 04: Electronic Control Unit (ECU) Performance
Circuit/System Description
The electronic brake control module (EBCM) detects an internal malfunction.
Conditions for Running the DTC
The ignition switch is in the ON position.
Conditions for Setting the DTC
An internal EBCM malfunction exists.
Action Taken When the DTC Sets
One or more of the following actions may occur:
| • | The antilock brake system (ABS) and vehicle stability enhancement system (VSES) are disabled. |
| • | TCS is degraded. |
| • | The ABS/TCS indicators turn ON. |
| • | The red BRAKE Warning indicator turns ON. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for Scan Tool Information
Circuit/System Verification
- Verify that DTC C0550 is not set.
| ⇒ | If the DTC is set, clear the DTC with a scan tool, and operate the vehicle within the conditions for setting the DTC. If the DTC reset, replace the EBCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for EBCM replacement, setup, and programming
