• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
The remote control door lock receiver (RCDLR) receives a radio frequency (RF) transmission from each tire pressure sensor. Each sensors RF transmission contains its own unique identification (ID) code that must be learned into the RCDLR memory. Once all 4 IDs have been learned and vehicle speed is 25 mph, or greater, the RCDLR continuously compares IDs in received transmission to its learned IDs to determine if all 4 sensors are present.
The ignition is ON.
The RCDLR has not undergone the programming procedure.
The driver information center (DIC) displays the SERVICE TIRE MONITOR warning message.
A current DTC will clear when the RCDLR has undergone the setup procedure.
A newly replaced RCDLR will set DTC C0569 on its initial ignition ON cycle. Tire type and tire pressure selection setup must be performed.
Tire Pressure Monitor Description and Operation
• | Circuit Testing |
• | Wiring Repairs |
Verify that the DTC C0569 is not set.
⇒ | If the DTC is set, program/setup the RCDLR. If the DTC resets, replace the RCDLR |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for RCDLR replacement, setup, and programming