Notice: DO NOT use fluid which has been bled from a hydraulic clutch system, in order to fill the clutch master cylinder reservoir, due to the possibility that the fluid may be aerated, have too much moisture content, or be contaminated and may cause system or vehicle damage.

1. Ensure the reservoir is filled to the fill line with new hydraulic clutch fluid. Add fluid if required. Use hydraulic clutch fluid GM P/N 12345347 (Canadian P/N 10953517).
2. Press the clutch pedal in completely to the floor panel.
3. Open the bleeder screw in order to purge the air from the system.
4. Close the bleeder and release the clutch pedal.

Important: Ensure no air is drawn into the clutch system.

5. Repeat steps 2, 3, and 4 until all the air is out of the clutch system.

5.1.	Check and refill the reservoir as needed while bleeding.

5.2.	After bleeding, pump the clutch pedal several times. If clutch engagement is not satisfactory, repeat the bleed procedure.

6. If the previous procedures are unsuccessful, perform the following steps.

6.1.	Pump the clutch pedal very fast with full strokes for 30 seconds.

6.2.	Stop pumping and let the air escape into the reservoir while moving the rubber pad up and down 12 mm (0.5 in) for 30 seconds.

6.3.	Repeat this procedure, as necessary.