GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2001 🢒 Sonoma Pickup - 2WD 🢒 Engine 🢒 Engine Electrical 🢒 Evaporator Tube Replacement

Evaporator Tube Replacement 2.2L

Tools Required

J 39400-A Halogen Leak Detector

Removal Procedure
  1. Remove the battery. Refer to Battery Replacement in Engine Electrical.
  2. Recover the refrigerant from the system. Refer to Refrigerant Recovery and Recharging .

    3. Object Number: 3723 Size: SH
  3. Remove the evaporator tube retaining screw.
  4. Remove the evaporator tube clip from the accumulator.
  5. Remove the evaporator tube from the evaporator.
  6. Remove the O-ring seal and discard.
  7. Remove the air intake resonator.

    8. Object Number: 281178 Size: SH
  8. Remove the evaporator tube from the condenser.
  9. Remove the O-ring seal.

Installation Procedure
  1. Install a new O-ring seal. Refer to O-Ring Replacement in Heating, Ventilation and Air Conditioning.

    2. Object Number: 281178 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the evaporator tube to the condenser.

    3. Tighten
    Tighten the evaporator tube to 28 N·m (21 lb ft).

  3. Install the air intake resonator (2.2L only), or the lower radiator hose (4.3L only).
  4. Install a new O-ring seal. Refer to O-Ring Replacement in Heating, Ventilation and Air Conditioning.

    5. Object Number: 3723 Size: SH
  5. Install the evaporator tube to the evaporator.

    6. Tighten
    Tighten the evaporator tube to 28 N·m (21 lb ft).

  6. Install the evaporator tube clip to the accumulator.
  7. Install the evaporator tube retaining screw.

    8. Tighten
    Tighten the screw to 1.9 N·m (17 lb in).

  8. Install the battery. Refer to Battery Replacement in Engine Electrical.
  9. Evacuate and recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging .
  10. Leak test the fittings components using the J 39400-A .