GM Service Manual Online
For 1990-2009 cars only

Diagnostic Aids

Hard shifting in reverse can be diagnosed easily. You should also perform a static shift and a dynamic shift test. Many simple factors could occur such as excessive clutch pedal free travel, insufficient fluid, excessive fluid or even the wrong transmission lubricant. A misaligned transmission can also cause hard shifting as well as a worn or defective clutch, binding of the shift control. Many internal components can also play a factor in hard shifting such as the front bearing retainer loose or cracked, synchronizer worn, damaged or improperly assembled. A failure to fully depress the clutch pedal when shifting will cause hard shifting in reverse.

Test Description

The number(s) below refer to the step number(s) on the diagnostic table.

  1. This step checks for air in the hydraulic lines, this will also cause the transmission to hard shift in reverse.

  2. This step checks for a faulty shift control.

  3. This step checks for a faulty or worn clutch pressure plate or clutch driven plate.

Step

Action

Yes

No

DEFINITION: The transmission does not shift smoothly or without difficulty into reverse gear.

1

Did you review the manual transmission symptom operations and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Manual Transmission

2

Inspect the clutch pedal travel.

Is there sufficient clutch pedal travel?

Go to Step 3

Go to Step 4

3

Remove any clutch pedal restrictions.

Does the transmission shift hard in reverse?

Go to Step 4

System OK

4

Test for air in the clutch hydraulic system.

Is there air in the hydraulic system?

Go to Step 5

Go to Step 6

5

Bleed the air from the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding in Clutch.

Did you find and repair the condition?

System OK

Go to Step 6

6

Inspect the transmission shift control for binding.

Is the transmission shift control binding?

Go to Step 7

Go to Step 8

7

Replace the transmission shift tower. Refer to Shift Tower Replacement .

Did you find and repair the condition?

System OK

Go to Step 8

8

Check the transmission for the correct type transmission fluid.

Is the correct type fluid being used?

Go to Step 10

Go to Step 9

9

Drain and refill the transmission with the correct type fluid.

Does the transmission still shift hard in reverse?

--

System OK

10

Inspect the clutch pressure pate and/or clutch driven plate.

Is the clutch pressure plate and/or clutch driven plate worn or faulty?

Go to Step 11

Go to Step 12

11

Replace the clutch pressure plate and/or clutch driven plate. Refer to Clutch Assembly Replacement in Clutch.

Did you find and repair the condition?

System OK

Go to Step 12

12

Remove the transmission. Refer to Transmission Replacement .

Inspect the transmission for an internal bind, possibly caused by one of the following:

    • Shift forks
    • Selector plates
    • Synchronizers

Is there an internal bind?

Go to Step 13

--

13

  1. Replace worn or damaged components as necessary. Refer to Transmission/Transaxle Unit Repair Manual.
  2. Install the transmission. Refer to Transmission Replacement .

Did you find and repair the condition?

Go to Step 14

Go to Diagnostic Aids

14

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 1