Removal Procedure
- Raise the window to the closed position.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect
the battery negative cable.
- Remove the door trim panel. Refer to
Front Side Door Trim Panel Replacement
.
- Remove the water deflector. Refer to
Door Water Deflector Replacement
.
- Remove the
inside door lock rod (1) from the lock assembly.
- Remove the inside door handle rod (2) from the lock assembly.
- Remove the outside door
lock rod (1) from the lock assembly.
- Remove the outside door handle rod (2) from the lock assembly.
- Disconnect the power actuator wiring connector, if equipped.
- Remove the fasteners that retain the lock assembly to the door.
- Remove the lock assembly from the door.
Installation Procedure
- Install the lock assembly to the door.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the fasteners
that retain the lock assembly to the door.
Tighten
Tighten the fasteners to 9 N·m (80 lb in).
- Connect the power actuator wiring connector, if equipped.
- Install the outside door
handle rod (2) to the lock assembly.
- Install the outside lock rod (1) to the lock assembly.
- Install the inside door
handle rod (2) to the lock assembly.
- Install the inside door lock rod to the lock assembly (1).
- Install the water deflector. Refer to
Door Water Deflector Replacement
.
- Install the door trim panel. Refer to
Front Side Door Trim Panel Replacement
.
- Connect the battery negative cable.