Removal Procedure
- Remove the screws that retain the data link connector (DLC) to
the instrument panel sound insulator.
Feed the DLC lines through the hole in the sound insulator.
- Remove the screws that
retain the instrument panel sound insulator to the knee bolster and the cowl
panel.
- Disconnect the electrical connectors from the remote control door
lock receiver module.
- Remove and retain the remote control door lock receiver module
from the instrument panel sound insulator (if equipped).
Installation Procedure
- Install the remote control
door lock receiver module to the instrument panel sound insulator.
- Connect the electrical connector to the remote door lock receiver
module.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the screw
that retains the instrument panel sound insulator to the cowl panel.
Tighten
Tighten the screw to 1.9 N·m (17 lb in).
- Install the screws that retain the instrument panel sound insulator
to the knee bolster.
Tighten
Tighten the screws to 1.9 N·m (17 lb in).
- Feed the DLC through the hole in the instrument panel sound insulator.
- Install the screws that retain the DLC to the instrument panel
sound insulator.
Tighten
Tighten the screws to 2.4 N·m (21 lb in).