GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 748  Size: SH
  1. Remove the handle from the handle assembly. Refer to Rear Door Inside Handle Replacement .
  2. Remove the endgate trim panel. Refer to Endgate Trim Panel Replacement .

  3. Remove the endgate bellcrank rod from the endgate inside handle assembly.
  4. Remove the screws that retain the endgate cover to the endgate.
  5. Remove the endgate cover from the endgate.
  6. Release the endgate latch rods from the latch rod clips.

  7. Object Number: 595761  Size: SH
  8. Drill out the rivets that secure the handle assembly to the endgate.
  9. Remove the handle from the endgate cover.

Installation Procedure


    Object Number: 595761  Size: SH
  1. Install the inside handle assembly to the endgate cover using 2 rivets.

  2. Object Number: 748  Size: SH
  3. Install the endgate bellcrank rod to the endgate inside handle assembly.
  4. Secure the endgate latch rods to the latch rod clips.
  5. Install the endgate cover to the endgate.
  6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Install the screws that retain the endgate cover to the endgate.
  8. Tighten
    Tighten the screws to 1.2 N·m (11 lb in).

  9. Install the endgate trim panel. Refer to Endgate Trim Panel Replacement .
  10. Install the handle to the inside handle assembly. Refer to Rear Door Inside Handle Replacement .