Test Description
The number(s) below refer to the step number(s) on the diagnostic table.
-
This step will test the if the sunroof will slide to the open position. If it opens, then inspect the sunroof limit switch LS2 for a stuck switch causing an intermittent short to ground.
-
Testing for a short to ground in the sunroof limit switch LS2 circuit or a stuck or closed limit switch.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Schematic Reference: Sunroof Schematics DEFINITION: Sunroof only slides between the closed and vent positions, does not open. | ||||
1 | Did you perform A Diagnostic System Check - Power Sunroof? | -- | Go to Step 2 | |
Operate the power sunroof to the open position. Does the system operate normally? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 | |
3 |
Does the voltage measure near the specified value? | 4.5-5.5 V | Go to Step 6 | Go to Step 4 |
Did you find and correct the condition? | -- | Go to Step 7 | Go to Step 5 | |
5 | Replace the sunroof opening position switch. Refer to Sunroof Position Encoding System Switch Replacement . Did you complete the replacement? | -- | Go to Step 7 | -- |
6 | Replace the sunroof module. Refer to Power Sunroof Module Replacement . Did you complete the replacement? | -- | Go to Step 7 | -- |
7 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 3 |
