GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 1997 🢒 Sonoma Pickup - 4WD 🢒 Engine 🢒 Engine Controls - 4.3L 🢒 Fuel Level Sender/Gauge Module

Removal Procedure
  1. Disconnect the negative battery cable. Refer to

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

    .
  2. Remove the lower right I/P sound insulator. Refer to section 10 A.

    3. Object Number: 58501 Size: SH
  3. Lower the Fuel Level Sender Gauge Module by peeling away the velcro strip from the lower side of the Instrument Panel Storage Compartment.
  4. Remove the module end cover.
  5. Remove the circuit board inside the module housing being careful not to bend or twist the circuit board.

Installation Procedure

    Object Number: 58501 Size: SH
  1. Install the circuit board inside the module housing being careful not to bend or twist the circuit board.
  2. Install the module end cover.
  3. Install the Fuel Level Sender Gauge Module by pressing the module to the lower side of the Instrument Panel Storage Compartment where the velcro strip is applied.
  4. Install the lower right I/P sound insulator. Refer to section 10 A.
  5. Connect the negative battery cable.