- Remove the EGR adapter.
- Remove the engine accessory bracket.
- Remove the engine lift bracket from the rear
of the engine.
- Remove the cylinder head bolts.
- Remove the cylinder head.
- Clean the following areas:
• | Clean any carbon deposits from the combustion chambers. |
• | Clean all traces of the old cylinder head gasket from the cylinder
head and from the engine block. |
| Important: Do not use abrasive pads to clean the cylinder head or block surfaces.
An abrasive pad will damage the cylinder head and block surfaces. Abrasive
pads also produce a fine grit that will contaminate the engine oil.
It is only necessary to remove the gasket material. Do not attempt to
remove all marks from the cylinder head gasket surfaces.
|
• | Clean the cylinder head bolt threads. |
• | Clean the threads that are in the engine block. |
- Inspect the engine block to cylinder head mating surface for the
following conditions: