Did you perform the Power Sunroof System Check?

--

Go to Step 2

Go to Power Sunroof System Check

1. Disconnect connector C1.
2. Turn the ignition switch to the RUN position.
3. Using a J 39200 digital multimeter (DMM), measure the voltage at CKT 1001 (YEL) to ground.

Is the voltage within the specified range?

9-16 V

Go to Step 3

Go to Step 4

Measure the voltage between CKT 1001 (YEL) and CKT 1850 (BLK).

Is the voltage within the specified range?

9-16 V

Go to Step 6

Go to Step 5

Repair the open in CKT 1001 (YEL) between the sunroof module and the BBEC.

Is the repair complete?

--

Go to Power Sunroof System Check

--

Repair the open in CKT 1850 (BLK) between the sunroof module and G202.

Is the repair complete?

--

Go to Power Sunroof System Check

--

1. Reconnect connector C1.
2. Disconnect connector C2 at the sunroof module.
3. Measure the continuity from cavity 2 (BRN) and cavity 3 (BLU) while depressing the switch in the OPEN position.

Is the resistance equal to or less than the specified value?

1 ohms

Go to Step 7

Go to Step 8

Measure the continuity from cavity 3 (BLU) and cavity 5 (ORN) while depressing the switch in the CLOSE position.

Is the resistance equal to or less than the specified value?

1 ohms

Go to Step 11

Go to Step 9

Inspect for an open from the sunroof switch and cavity 2 (BRN) and cavity 3 (BLU). Repair as necessary.

Did you locate and repair an open circuit?

--

Go to Power Sunroof System Check

Go to Step 10

Inspect for an the open from the sunroof switch and cavity 3 (BLU) and cavity 5 (ORN). Repair as necessary.

Did you locate and repair an open circuit?

--

Go to Power Sunroof System Check

Go to Step 11

Replace the sunroof control switch.

Is the repair complete?

--

Go to Power Sunroof System Check

--

1. Reconnect connector C2.
2. Turn the igniiton switch to the RUN position.
3. Measure the voltage at connector C1, cavity A (LT GRN) to ground while depressing the sunroof switch in the OPEN position.

Is the voltage within the specified range?

9-16 V

Go to Step 12

Go to Step 14

Measure the voltage at connector C1, cavity C (DK GRN) to ground while depressing the sunroof switch in the CLOSE position.

Is the voltage within the specified range?

9-16 V

Go to Step 13

Go to Step 15

1. Inspect the cables for foreign objects or binding. Repair the cables as necessary.
2. If OK, replace the sunroof motor.

Is the repair complete?

--

Go to Power Sunroof System Check

--

Inspect for an open in the circuit between connector C1 cavity A and the sunroof motor. Repair as necessary.

Did you locate and repair an open circuit?

--

Go to Power Sunroof System Check

Go to Step 15

Inspect for an open in the circuit between connector C1 cavity C and the sunroof motor. Repair as necessary.

Did you locate and repair an open circuit?

--

Go to Power Sunroof System Check

Go to Step 16

Replace the sunroof module.

Is the repair complete?

--

Go to Power Sunroof System Check

--