Evaporative Emission Canister Replacement Pickup

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the canister mount bolt (2).



3. Disconnect the vent hose (3) from the canister (2).
4. Disconnect the fuel tank pipe and the purge pipe from the canister.
5. Remove the evaporative emission (EVAP) canister.

1. Connect the fuel tank pipe and the purge pipe to the canister.
2. Connect the vent hose (3) to the canister (2).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the canister mount bolt (2).

Tighten
Tighten the canister mount bolt to 12 N·m (106 lb in).

4. Lower the vehicle.

Evaporative Emission Canister Replacement 2-Door Utility

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the left rear shield.
3. Remove the canister retainer (1).



4. Disconnect the vent hose (2) from the canister (1).
5. Disconnect the fuel tank pipe and the purge pipe from the canister.
6. Remove the EVAP canister.

1. Install the EVAP canister.
2. Connect the fuel tank pipe and the purge pipe to the canister.
3. Connect the vent hose (2) to the canister (1).



4. Install the canister retainer (1).
5. Install the left rear shield.
6. Lower the vehicle.