For 1990-2009 cars only
Removal Procedure
- Disable the air bag. Refer to Disabling the SIR System in SIR.
- Remove the left sunshade. Refer to Sunroof Sunshade Replacement in Roof.
- Remove the left windshield garnish. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
- Remove the sunroof molding trim, if equipped. Refer to Sunroof Replacement in Roof.
- Remove the left rear assist handle. Refer to Assist Handle Replacement .
- Remove the upper console.
- Using a flat-bladed tool, gently pry out the air temperature sensor.
- Disconnect the electrical connector from the air temperature sensor.
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury
In order to avoid the above conditions, observe the following guidelines:
• Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Connect the electrical connector from the air temperature sensor.
- Install the air temperature sensor.
- Install the upper console.
- Install the left rear assist handle. Refer to Assist Handle Replacement .
- Install the sunroof molding trim, if equipped. Refer to Sunroof Replacement in Roof.
- Install the left windshield garnish. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
- Install the left sunshade. Refer to Sunroof Sunshade Replacement in Roof.
- Enable the air bag. Refer to Enabling the SIR System in SIR.
