Special Tools

Important: Setting the camshaft timing is required whenever the camshaft drive system is disturbed to ensure the relationship between any chain and sprocket is not lost. Even when only one sprocket is involved, multiple crankshaft rotations will not produce conditions where correct timing can be confirmed. If required, follow the Secondary Camshaft Drive Chain Replacement - Right Side installation procedure to reset the camshaft timing.

1. Remove the engine assembly. Refer to Engine Replacement .
2. Remove the bank 2 cylinder head cover. Refer to Camshaft Cover Replacement - Left Side .
3. Remove the camshaft position sensor. Refer to Crankshaft Position Sensor Replacement .
4. Remove the camshaft position actuator solenoids.
5. Remove the crankshaft pulley. Refer to Crankshaft Balancer Replacement .
6. Install the EN 46111 onto the crankshaft.
7. Rotate the crankshaft until the camshafts are in a neutral low tension position. The camshaft flats (1) will be parallel with the cylinder head cover rail (2).



8. Install EN 46105  (1) onto the bank of the bank 2 cylinder head camshafts (2).




Important: Use an open-end  (1) at the camshaft hex (2) to prevent camshaft/engine rotation. Do not remove the camshaft position actuator bolt at this time.

9. Loosen the camshaft position actuator bolt.




Important: If you have already removed the camshaft timing chain, proceed to Step 13.

Important: Ensure the tips of EN 46108 are fully engaged into the timing chain and the wing nuts are tight and the timing chain is taught.

10. Install EN 46108  (1 and 2) to retain the timing chain (3 and 4).
11. Firmly tighten the wing nuts of EN 46108 .

Important: Ensure the camshaft timing chain and the camshaft position actuators are marked for correct reassembly.

12. Mark the timing chain and the respective location on both camshaft position actuators.



13. Remove the bolt (1) attaching the bank 1 exhaust camshaft position actuator (2) and remove the actuator.

1. Clean the exterior of each camshaft position actuator with solvent.
2. Dry the timing components with compressed air. Inspection

1. Inspect the front of each camshaft position actuator for the following:

•	Sprocket damage (1)

•	Reluctor/sensor wheel damage (2)

•	Camshaft position actuator bolt seating/sealing inner hub flange damage (3)

2. Inspect the back of each camshaft position actuator for the following:

•	Sprocket damage (1)

•	Camshaft locating pin damage (2)

•	Camshaft seating/sealing inner hub flange damage (3)

•	Blockage to the oil passages (4)

•	Loose or missing housing bolts (5)

1. Installation should follow the removal procedure in the reverse order.
2. Align the actuators and timing chain with the marks made during removal.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the camshaft position actuators.

Tighten
Tighten the camshaft position actuator attaching bolts to 58 N·m (43 lb ft).

4. Remove the timing chain retention tools.