Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the drain plug (1).
- Remove the fill plug (2)
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the drain plug (1).
Tighten
Tighten the drain plug (1) to 39 N·m (29 lb ft).
- Fill the transfer case with synthetic hypoid 75W-90 to the bottom of the fill plug hole, when the vehicle is on a level surface.
- Install the fill plug (2).
Tighten
Tighten the fill plug (2) to 39 N·m (29 lb ft).
- Lower the vehicle.