GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2007 🢒 Terrain 🢒 Safety and Security 🢒 Remote Functions 🢒 DTC B3105

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B3105: Keyless Entry System Key Fobs Not Programmed

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Keyless Entry System Key Fobs Not Programmed

--

--

--

B3105 00

Circuit/System Description

DTC B3105 sets if the remote control door lock receiver (RCDLR) has not learned any key fobs.

Conditions for Running the DTC

The remote function actuation (RFA) system must be enabled and a test is ran every time the key is cycled.

Conditions for Setting the DTC

This code is set if there are no learned key fobs in the RCDLR.

Action Taken When the DTC Sets

The RFA system is inoperative.

Conditions for Clearing the DTC

The code is cleared as current when at least one fob is programmed to the RCDLR.

Reference Information

Schematic Reference

Remote Function Schematics

Connector End View Reference

Remote Function Connector End Views

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Scan Tool Data List

Special Tools Required

J 43241 Keyless Entry Tester

Circuit/System Testing
  1. Verify that the transmitter is the correct transmitter for the vehicle.
    2. ⇒If not the correct transmitter, replace the transmitter.
  2. Verify the scan tool FOB Programmed parameter is Yes.
    3. ⇒If not Yes, program the transmitter.
  3. Place the transmitter on the test pad of the J 43241 and press each button of the transmitter one at a time. The tester should sound a tone and illuminate a green light when each button is pressed.
    4. ⇒If none of the buttons sounds the tone and illuminates the green light, replace the transmitter battery.
    ⇒If one or more of the buttons sounds the tone and illuminates the green light, replace the transmitter.
  4. Verify the scan tool FOB Function responds to every function on the transmitter.
    5. ⇒If it does not respond to every function, test the keyless entry antenna for an open/high resistance.
  5. Replace the RCDLR module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for RCDLR replacement, setup, and programming