Special Tools

DW-110-060 Engine Assembly Support Fixture

Note: Only lift the engine far enough to take the weight off the transaxle rear mount assembly, or damage to the mount and lifting equipment failure may occur.

1. Support the engine assembly using DW-110-060 fixture .



2. Remove the transaxle rear mount-to-bracket through bolt.
3. Remove the transaxle rear mount bracket retaining bolts from the transaxle.
4. Remove the transaxle rear mount bracket.
5. Remove the transaxle rear mount retaining bolts from the cradle.
6. Remove the transaxle rear mount.

Caution: Refer to Fastener Caution in the Preface section.




1. Install the transaxle rear mount to the cradle and tighten the retaining bolts to 90 N·m (66 lb ft).
2. Install the transaxle rear mount bracket to the transaxle and tighten the retaining bolts to 90 N·m (66 lb ft).

Note: Before tightening the transaxle rear mount through bolt, swing the engine assembly backwards and forwards or from the side to side for the proper alignment.

3. Install the transaxle rear mount through bolt and tighten to 90  N·m (66 lb ft).
4. Remove the engine support fixture DW-110-060 fixture .