Tools Required
Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.
Important: Let the SIR coil assembly hang freely after removal.
- Remove the SIR coil assembly. Refer to
Inflatable Restraint Steering Wheel Module Coil Replacement
.
- Compress the shaft lock shield assembly using
J 23653-SIR
and
J 42137
.
- Remove the bearing retainer (1) from the steering shaft
assembly.
- Discard the bearing retainer.
- Remove
J 23653-SIR
and
J 42137
from
the steering shaft assembly.
- Remove the following parts
from the steering shaft assembly:
7.1. | The shaft lock shield assembly (4) |
7.2. | The turn signal cancel cam assembly (3) |
7.3. | The upper bearing spring (2) |
7.4. | The thrust washer (1) |
Installation Procedure
- Install the following
parts onto the steering shaft assembly:
1.1. | The thrust washer (1) |
1.2. | The upper bearing spring (2) |
1.3. | Lubricate the turn signal cancel cam assembly with GM P/N 12377900
(Canadian P/N 10953529) |
1.4. | The turn signal cancel cam assembly (3) |
1.5. | The shaft lock shield assembly (4) |
- Compress the shaft lock
shield assembly using
J 23653-SIR
and
J 42137
.
- Install the new bearing retainer (1) onto the steering
shaft assembly.
- Firmly seat the bearing retainer (1) into the groove on
the steering shaft assembly.
- Remove
J 23653-SIR
and
J 42137
from
the steering shaft assembly.
Caution: Improper routing of the wire harness assembly may damage the inflatable
restraint steering wheel module coil. This may result in a malfunction of
the coil, which may cause personal injury.
- Install the SIR coil assembly. Refer to
Inflatable Restraint Steering Wheel Module Coil Replacement
.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.